![]() Love all the MN kit but hate the documentation. ![]() And I was experiencing just what you talked about- the state I was in not showing up in the m-paste page. I've stared at those pages in the manual so many times- and never figured out WTF or HTF to paste a state to another state so I could save it. Just wanted to say thanks for posting this up. Does that make sense? It happens to me all the time. Hold the m-paste pad (x) it should take you up a level and if, once you’ve done that you see a see a state glowing red and a state glowing orange, that means you aren’t in the right page and you should (I’m trying to remember here) select the orange one so as the red one is no longer lit, then hit (x) again and you should see what you’re expecting. If you aren’t seeing seeing the active state illuminated in orange or red on the m-paste page, it could mean that you are not on the correct m-paste page. I remember originally it confusing me a bit because it enables 2 very different functionalities, the Mesh and the Paste. Many thanks and sorry for a question that probably should be obvious to me.ĮDIT Ah yes! M-Paste is coming back to me now. Even going through the manual I'm having a hard time finding an answer to that. Slap of reality for me that sometimes you have to consider your modules almost as instruments where you have to practice them now and then or you risk loosing what you have learned.Īnyhow, Say I have state 3 in bank 1 running, is there an easy way to save it to a state in another bank? Some good things happened today, but I'm currently in a bank where I don't want to overwrite any of the current states, and I know I have banks that are empty, but I just can't figure out how. I did at one point, but the past 4 months I have to admit that I've been frequently engaged with the USTA, and with that sacrificed that deep knowledge that I once had with the Rene2. Needing some help from people that know the module well. In this case, the meter or bars of each sequence could be the same but the tempo and timing of each gate event and the ensuing melodies will be different but (hopefully) related to eachother. ![]() So now the advancement of the clocks on each channel is following a different tempo regardless of access settings. POLYRHYTHM: Feed different but somewhat related tempo clocks into X and Y channels clocks inputs. However, both channels will typically have the same tempo. So if you had a 4 step sequence on X (only access to 4 steps) and an 8 step sequence on Y, they would repeat together every two cycles on X. This is equivalent to changing the sequence length, so the two channels will be going in and out of sync with eachother occasionally lining up again and then phasing out. POLYMETER: Set up different settings for ACCESS on X versus Y. If we are just talking X and Y channels then: Rene will only advance to the next step when gates are received, hence, if you send it odd division off gates, you will have some polyrythms happening.Ĭool.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |